Safety Data Sheets

Safety data sheets (SDS) and technical data sheets (TDS) are available to download for standard alloys and fluxes in our range. SDS documents provide essential information on composition, hazard identification, handling and storage, personal protective equipment requirements and emergency response procedures.

If you require a document for a product not listed below, contact us and we will provide it promptly. All SDS documents are maintained in compliance with current REACH and COSHH requirements.

  • Ventilate

    Brazing produces fumes from base metal coatings, zinc and cadmium content in some filler metals, and fluorides in fluxes. Use ventilating fans and exhaust hoods to carry all fumes away from the work area. Air-supplied respirators may be required in confined spaces.

  • Clean base metals

    Surface contaminants of unknown composition add to the fume hazard and can prevent proper alloy bonding. Ensure all components are free of oil, grease and unknown coatings before brazing.

  • Apply sufficient flux

    Proper flux coverage helps suppress outgassing of volatile elements. Consult the SDS for specific hazards associated with the flux in use.

  • Heat broadly

    Intense, localised heating consumes flux rapidly and increases fuming. Apply heat to the base metals broadly and uniformly — never directly to the filler metal.

  • Know your base metals

    Cadmium-coated and zinc-coated (galvanised) base metals produce toxic fumes during heating. Check that base metals do not have these coatings before brazing.

  • Know your filler metals

    Each filler metal carries a warning label — read it and follow the instructions. Consult the SDS for the maximum recommended brazing temperature of the specific filler metal in use.

COSHH and REACH Compliance

All GS Metal Joining silver brazing alloys are manufactured from virgin raw materials and comply with current REACH and RoHS cadmium content limits. COSHH assessments for brazing operations should be based on the SDS documents for the specific alloys and fluxes in use, together with workplace exposure monitoring where required.

If you require an SDS or TDS for any alloy or flux in our range not listed above — including AG103, AG106, AG107, AG205, AG206, AG207, L-AG45SnSi, all copper phosphorus alloys, Stay-Silv White, Stay-Silv Black, Stay-Clean Aluminium and GS30 paste flux — contact us and we will provide the document promptly.

Note: The information contained in our safety data sheets is believed to be accurate but GS Metal Joining Ltd assumes no liability for its accuracy or completeness. Final determination of the suitability of a product remains the responsibility of the user.